1X Digital Electric Desoldering Pump Desoldering Absorb Vacuum Solder Sucker Gun

Description: Item specifics Condition New: A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is ... Read moreabout the condition Brand Unbranded Type Unbranded Tempeture 160-480 degree Application1 For PCB (Printed Circuit Board) repair is_customized No Model Number Pro'sKit SS-331H Power 90W UPC Does not apply Item description from the seller 1X Digital Electric Desoldering Pump Desoldering Absorb Vacuum Solder Sucker Gun Package List : 1 x 220V LCD Desoldering Station 1 x Electric Desoldering Gun 1 x Stand 3 x Spare tip(Diameter 1.2 1.0 1.5mm) 3 x Cleaning tool(Diameter 0.7 0.9 1.2mm) 4 x Filter sponge(Diameter 20.8x1 16.8x3) USE Notice: 1.After Each Use. It is Recommended to take 3-5 times of Empty Suction to Full Clear the residual Tin in The Tube. 2.If the interval is about 20 minutes, it is recommended to use a needle to clean the steel pipe after empty suction. 3.During the use, If the suction is reduced. Please use a needle to clean the steel pipe. 4.If you do not use often, it is recommended to adjust the tin gun to about 200 degrees, and then adjust to the working temperature when using it 5.When there is about 1/2 of the tin slag in tin storage. It should be cleaned in time. When the filter Spong is hardness,Pls replaced in time. 6.The Reason For Block Desoldering Gun 1)The temperature is set too low for long time desoldering, The solder Tin does not reach the storage tube,But the temperature comes down.So they Stayed in the tube,Make it Block 2)Did not clean in time when too much tin slag in the tin storage tube , This will effect the Gun's suction , In this case , you should remove tail's tin slag . it can be removed only after you use the soldering iron to heat the tin until it melt eBay Cross Border Trade powered by ChannelEffect

Price: 228.3 USD

Location: JH

End Time: 2025-01-19T04:45:44.000Z

Shipping Cost: 0 USD